+86 159 6711 5540 [email protected]

RF Coaxial Cable Selection Guide

From impedance to construction — 5 steps to the right model

Choosing the wrong cable means excess attenuation, high VSWR, even system failure. This guide narrows 295 models down to the one you need, the way an engineer thinks.

Step 1: Fix the system impedance

Mobile radio, RF/microwave and feeder systems use 50Ω; CATV and video surveillance use 75Ω. This is a hard constraint — they are not interchangeable.

Step 2: Choose the size

Common 50Ω sizes: 1/4″, 3/8″, 1/2″, 7/8″, 1-1/4″, 1-5/8″. Higher frequency, power or longer runs need larger cables. Base station feeders are typically 1/2″ or 7/8″.

Step 3: Pick the construction

Corrugated copper (low loss, outdoor feeder) / corrugated aluminium (lightweight, cost-effective) / super-flexible helical (jumpers, tight bends) / air-dielectric (ultra-low loss, long runs) / leaky cable (tunnel coverage).

Step 4: Check key parameters

Attenuation (dB/100m at your frequency), VSWR, power handling, bend radius, jacket flame rating (PVC / LSZH / PVDF). Every model's spec table lists these.

Step 5: Connectors and delivery

Confirm connector type (4.3-10, DIN, N-type), cut-to-length, pre-termination, labeling and packaging to reduce on-site waste.

Send us your frequency, distance and application — our engineers will recommend a model and quote within one business day.

Ask an engineer →
CallWhatsAppQuote